Record Mode - Q-See QS434 User Manual

DEVICE OPERATION
Audio Settings: In your Multimedia player interface, go to the Setting menu on your toolbar. From there, go to
SettingAudio Channel SettingNormal Video Bar (Figure 3.5.13). This will open up a dialog as illustrated in
Figure 3.5.14 allowing you to choose from a drop down list of which audio channels to play. Make your choice from
the options provided in the drop down list and click
Please note that these setting changes will not take effect until you re-start your multimedia player.

3. RECORD MODE

Configure record parameters, enable/disable audio.
NOTE: Audio capable cameras or powered microphones (not included) are required for audio recording.
To configure recording options:
1) Under CHANNEL, use the drop-down menus and select ON/OFF to enable/disable recording for the selected
channel.
2) Under RESOLUTION, select HIGHEST, HIGH, or NORMAL.
DVR-4CH: Setup resolution and code rate for recording, there are three options: HIGHEST, HIGH, NORMAL,
corresponding to D1, HD1, CIF resolution.
PAL: D1@6fps, HD1@12FPS, CIF@24fps;
NTSC: D1@7fps, HD1@15FPS, CIF@30fps;
Figure 3.5.13
Figure 3.5.15
18 |
next to "The channel has sound data". Click Apply then OK.
P a g e
Model #: QS434
Figure 3.5.14