Recording; Record Setup - Q-See QT5116 User Manual

BASIC FUNCTIONS
To Delete a user, the Administrator should follow these steps:
Step 1: Choose a user from the list of Users and the system will display their setting and permission levels. Click on
the Delete button to delete the intended user. A security window will appear as shown in Fig 3.7 Delete User
confirming the deletion of this user.
Step 2: Click the OK button and the user is deleted.

3.3 Recording

3.3.1 Record Setup

Users need to install and format a HDD, and set all the recording parameters before recording.
Note: Some vendors sell the DVR with a hard drive already installed, if this is the case you just need to set the
recording parameters.
There are four recording modes. Users can enable them simultaneously, but only one recording mode works at a
time. They have different priorities as depicted below:
Motion detection recording > Sensor recording > Manual recording > Timer recording
Right click on the mouse to enter the control bar functions illustrated in Fig 4.1Control Bar. Click Enter
Menu---->System.
Step 1: Enter RECORD configuration, refer to Fig 3.8: Record Setup. Select cameras from the pull down menu.
Fig 3.7: Delete User
Fig 3.8: Record Setup
16 | P a g e
QT518 & QT5116 User Manual