Maintenance - Ryobi EPN-7582P User Manual

GB
F D E
OPERATION
Start the planer and let the motor reach maximum
speed.
Hold the planer firmly and push it forward into the
work, using a slow, steady motion.
Apply downward pressure to keep your planer flat at
the beginning and the end of the work surface.
PLANING EDGES AND MAKING RABBET
CUTS
The planer comes with an adjustable edge guide for
precision edge planing and rabbet cutting. Attach the
edge guide to either side of the planer for planing edges
and attach the edge guide to the left side for making
rabbet cuts.
TO ATTACH THE EDGE GUIDE FOR PLANING EDGES
(Fig. 7)
Follow these steps to attach the edge guide for
planing edges:
Unplug the planer.
Attach the bracket (13) to the desired side of the
planer using the knob bolt (12).
Attach the edge guide (14) to the bracket using the
knob nut (15) and the carriage head bolt (16).
Tighten the retaining knob securely.
TO PLANE EDGES (Fig. 8)
Follow the directions in the "Planing" section earlier in
this manual. Hold the edge guide firmly against the edge
of the work surface.
TO ATTACH THE EDGE GUIDE FOR MAKING
RABBET CUTS (Fig. 9)
Follow these steps to attach the edge guide for making
rabbet cuts:
Unplug the planer.
Attach the bracket to the left side of the planer using
the knob bolt.
Attach the edge guide loosely to the bracket using the
knob nut and the carriage head bolt.
Adjust the edge guide to the desired width for the
rabbet cut.
Tighten the retaining knob securely.
TO MAKE RABBET CUTS (Fig. 9)
Follow the directions in the "Planing" section earlier in
this manual. Hold the edge guide firmly against the edge
of the work surface.
I P NL S DK
English
The depth of the rabbet is determined by the depth of the
cut and the number of passes made along the work
surface. The maximum depth of the rabbet cut is 11 mm
and has to be cut in 2.5 mm passes, or less, to reach the
desired depth. The width of the rabbet cut is adjustable
by moving the edge guide.

MAINTENANCE

GENERAL
All parts represent an important part of the double
insulation system and should be serviced only at an
authorized service center.
Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to damage from various
types of commercial solvents and may be damaged by
their use. Use clean cloths to remove dirt, carbon dust, etc.
Electric tools used on fiberglass material, wallboard,
spackling compounds, or plaster are subject to
accelerated wear and possible premature failure because
the fiberglass chips and grindings are highly abrasive to
bearings, brushes, commutators, etc. Consequently,
we do not recommend using this tool for extended work
on these types of materials. However, if you do work with
any of these materials, it is extremely important to clean
the tool using compressed air.
LUBRICATION
All of the bearings in this tool are lubricated with a
sufficient amount of high-grade lubricant for the life of the
unit under normal operating conditions. Therefore,
no further lubrication is required.
10
N FIN GR H CZ
WARNING
When servicing, use only identical Ryobi
replacement parts. Use of any other part may
create a hazard or cause product damage.
WARNING
Do not at any time let brake fluids, gasoline,
petroleum-based products, penetrating oils, etc.
come in contact with plastic parts. They contain
chemicals that can damage, weaken, or
destroy plastic.
WARNING
Always wear safety goggles or safety glasses
with side shields during power tool operation or
when blowing dust. If operation is dusty,
also wear a dust mask. Failure to do so could
result in possible serious injury.
RUS RO PL