Table of Contents
Advertisement
Using the dust bag
Use the dust bag for smaller jobs.
Insert the dust bag adaptor into the dust port.
Empty the dust bag regularly to maintain optimum dust
collection.
Remove the battery and clean the dust port regularly.
Remove any clogging object using a suitable tool.
NOTE: Do not reach into the dust port with your hands.
They could be injured by rotating parts.
KICKSTAND
The product has been equipped with an automatic pivoting
kickstand that will prevent the blades from contacting the
workbench when not in use. As you begin the planing
operation, the kickstand will automatically retract as it
passes over the edge of the workpiece. When setting
the product down on the workbench, the kickstand will
automatically pivot down to prevent the blade from making
any contact.
WARNING
Make sure the kickstand operates freely at all times and
that the area surrounding the kickstand is clear of debris.
Failure to do so could result in serious personal injury.
MAINTENANCE
WARNING
The product should never be connected to a power
supply when assembling parts, making adjustments,
cleaning, performing maintenance, or when the product
is not in use. Disconnecting the product from the power
supply will prevent accidental starting that could cause
serious injury.
WARNING
When servicing, use only original manufacturer's
replacement parts, accessories and attachments. Use of
any other parts may create a hazard or cause product
damage.
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloths to remove dirt, carbon dust, etc.
WARNING
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
injury.
4
WARNING
For greater safety and reliability, all repairs should be
performed by an authorised service centre.
Always wear safety goggles or safety glasses with side
shields during power tool operation or when blowing
dust. If operation is dusty, also wear a dust mask.
Replace worn blades with new ones.
The blade has sharp edges and may also remain hot
after cutting operations. Exercise extreme caution
when cleaning an exposed blade. Wear gloves to
protect yourself from personal injury.
LUBRICATION
All of the bearings in the product are lubricated with a
the product under normal operating conditions. Therefore,
no further lubrication is required.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing
of as waste. The machine, accessories and
packaging should be sorted for environment-
friendly recycling.
SYMBOLS ON THE PRODUCT
Safety alert
No-load speed
V
Volts
Direct current
Please read the instructions carefully
before starting the machine.
Product meets applicable regulatory
requirements.
Maximum planing capacity
Maximum planing capacity
Wear eye protection
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your local authority or retailer
for recycling advice.
Advertisement
Table of Contents
