Ryobi EPN-7582P User Manual page 10

GB
F D E
MAINTENANCE
CLEANING THE EXHAUST PORT AND
EMPTYING THE DUST BAG (Fig. 10)
After using the planer for an extended period of time or
when planing wet or green lumber, chips may build-up in
the exhaust port and require cleaning. Chip build-up
restricts air flow and causes the motor to overheat.
Clean the exhaust port and empty the dust bag regularly:
Unplug the planer.
WARNING
Failure to unplug your planer could result in
accidental starting causing serious injury.
Remove the dust bag from the exhaust port.
Clean the chip or dust build-up from the exhaust port
of your planer with a small piece of wood. Do not use
your hands or fingers.
Empty all debris from the dust bag and ensure that
the collar is free of debris.
Replace the dust bag.
REPLACING BLADES (Fig. 11, 12 & 13)
The blades (11) in your planer are reversible. Therefore,
you can reverse the blades when one edge becomes dull.
Always replace or reverse blades in pairs. Do not attempt
to sharpen blades. If the blades become dull, replace them.
When replacing the blades, use recommended
replacement blade only.
WARNING
Blades are sharp, use extreme caution when
replacing the blades. Failure to heed this warning
can result in serious personal injury.
Unplug the planer.
WARNING
Failure to unplug the planer could result in
accidental starting causing serious injury.
Secure the planer in an upside down position.
Loosen the three screws securing the blade on the
blade holder (17) using the blade wrench provided.
NOTE: Do not over-loosen the screws. If screws are too
loose, alignment of the new blade will not be accurate.
I P NL S DK
English
NOTE: Before removing the old blades, take notice of the
direction of cut as well as how the tapered edge of the old
blades are oriented. The tapered edge of the new blades
must be in the same orientation as the original blades.
NOTE: If blade cannot be easily pushed out of blade
holder after loosening blade securing screws, use a block
of wood to break the blade loose from the blade holder,
with a short sharp blow. Then push the blade with a
screwdriver to remove. If necessary, tap the block of wood
sharply with a small hammer to break the blade loose.
REPLACING THE BELT (Fig. 14 & 15)
When replacing the belt, use the recommended
replacement belt only.
NOTE: Do not overtighten the screws.
11
N FIN GR H CZ
Push the blade (to the right) out of the blade holder
using the tip of a screwdriver.
Remove the old blade from the blade holder.
Clean any sawdust or wood chips from around the
blade area.
Slide the new blade into the slot of the blade holder.
Use a screwdriver to push the blade into the blade
holder until it is centered into position.
Retighten the three blade securing screws using the
blade wrench.
Repeat the above procedure to change the
other blade.
Unplug the planer.
WARNING
Failure to unplug the planer could result in
accidental starting causing serious injury.
Remove belt cover (18) screws.
Remove the belt cover.
Force the old belt from the small pulley (20) by
turning in the direction shown. As you turn the belt
(19), pull and work it off the small pulley until it has
been completely removed from both pulleys.
Install the new belt over the large pulley (21).
As you turn the belt, push and work it onto the small
pulley until it is in place.
Replace the belt cover.
Install belt cover screws and tighten securely, but do
not overtighten.
RUS RO PL