Midi/General; Volume Pedal - Generalmusic WK2000 SE Owner's Manual

owners manual
To access to the MIDI/GENERAL mode, press the relative MIDI/GENERAL button, and hold it down
for a few seconds. Use the PAGE buttons to scroll through the various pages. Move to the various
sections of a page with the CURSOR key.
•Pedal
This page allows you to assign a function to the pedal inserted in the appropriate jack on the instrument's back panel. Use
the DIAL or the +/- buttons of the right hand keypad to select the function that can be controlled by the pedal.
1 Sw Up1/2: Sets the Real UPPER 1 and UPPER 2 to ON or to OFF. This function is useful when
you wish to use two sounds alternatively but do not wish to interrupt the execution
2 St/Stp: Starts or stops the the drum pattern
3 Fill A: executes Fill IN A
4 Fill IN: executes Fill IN
5 Fill B: executes Fill IN B
6 Intro: adds the intro to the selected Variation
7 Ending: adds the ending to the selected Variation

• Volume PEDAL

A volume pedal (GEM prod. Code: 970013), connected to the rear of the instrument, can either control the overall
volume (ALL) or the single sections (SEC). Rotate the DIAL To switch from ALL to SEC. If the PAGE+ is pressed, the
display will show the following functions: Tuning, Dynamic, Serial Computer. Use the CURSOR button to select the
desired function, and rotate the DIAL to modify the values.
• Tuning
Value (-63/+63); this parameter shows the current general tuning status. Use the DIAL or the +/- buttons of the Sound
selection keypad to tune the instrument. The value of 00 corresponds to the standard Equal tuning, based on A = 440 Hz.
• KeyTouch
Value (00-127); the 3 digit display area shows a value between 0 and 127, corresponding to the current velocity
sensitivity setting for the keyboard. Use the DIAL or the +/- buttons of the right hand keypad to change the keyboard's
touch sensitivity.
• Serial
Connecting the WK2000 SE to a computer via a serial cable, you must confi gure this parameter for the type of
computer used (PC1, PC2, MAC)
Important!: If you do not connect the serial port, set this parameter to OFF (default), otherwise the MIDI interface will remain
disabled for use.
• TV
TV=PAL: enables the video standard according to the television used. You can choose between PAL (Europe) or NTSC
(U.S.A.)
• TV text
Enables the WK2000 SE for the projection of Song lyrics onto an external monitor or domestic TV set connected to
the instruments RGB or S-VHS ports. Use the DIAL or the +/- buttons of the right hand keypad to select the required
setting.
• MIDI
Channel, Local, Internal, G.Midi, Start/Stop, Chn.Lock and Dump. Modifi cations to CHANNEL and LOCAL can be saved
to the Performance.
• Channel
Use this menu to assign a MIDI channel to each track as required. To activate this parameter (which relates to the
individual tracks), press ENTER. The 3 digit display shows the number of the track (e.g. 01 = track n. 1). Select the
tracks with the +/-buttons. Rotate the DIAL to assign a MIDI channel to the track or to set the Off status. Another way
of instantly selecting a track is to press the corresponding function button (F1/F9). After the track n. 16, the +/- buttons
select the Common track, then the Chord track, both displayed with the associated channel number. Use the Dial to
assign a different MIDI channel to the Common and Chord track (the Chord track is useful for MIDI accordions refer to
the relevant paragraph in the MIDI chapter).

MIDI/General

MIDI/GENERAL
wk2000 se
Page53