Digital Signal Processor; How To Assign The Type Of Effect; Disabling The Effects; Controlling The Effect Send Level - Generalmusic WK2000 SE Owner's Manual

Multimedia workstation

Hide thumbs

Table of Contents

owners manual

WK2000 SE allows you to process Performances (Style/RealTime, Song Style, Song Performance) through the on-board

multi-effect processor and to make the overall sound more realistic.

The Digital Signal Processor is made by two units that process the Performances

with Reverb and Modulation/Delay effects. Each section has independent effects

Send control to regulate the effect volume level in the current Performance. The

DSP control buttons are located in the UTILITY area.

REV/CHO

When it is active (the LED indicator is ON), the current Performance is processed

from the type of effect assigned both to the Reverb and to the Chorus unit of the

DSP. The overall processed sounds can be heard over the internal speakers and

from the LEFT/RIGHT outputs. When it is not active (the LED is OFF) , the sound

is not processed by the DSP and no effect is given.

Assigning the effects

The way to assign effects to the current Performance is identical, no matter what the selected mode is (Style/Real

Time, Song Style, Song).

How to assign the type of effect

Press and the REV/CHO button for a few seconds

The effect currently assigned to the Performance is indicated in the dis-

play.

Use the CURSOR to move and rotate the DIAL to assign a different effect

You can scroll over the 22 different types of effect available for each DSP

unit. The same effect can be selected from both the DSP units

To control the general effect volume, move with the CURSOR button

to the volume and modify it by rotating the DIAL

To exit the effect function, use the arrow button or press ESCAPE

The selected effects have now been assigned to the current Performance

Press and hold STORE PERFORMANCE for a few seconds. Press ENTER

to save the changes in the current Performance

If a different Performance is selected, or if the same Performance is selected again before saving the changes, the new effect settings

will be lost and the Performance will be restored to the previous setting.

Disabling the effects

You can disable the effects assigned to the current Performance at any time,

by pressing the REV/CHO button.

Controlling the Effect Send Level

The appropriate effect (Reverb or Chorus) level can be set to each Performance track independently.

REVSEND

Controls the REVERB level in each Performance track

CHOSEND

Controls the CHORUS level in each Performance track

Select the track you wish to modify, using the function buttons

Note:

the Performance mode must be not active, besides, Single Touch Play must

not be active.

The selected track blink in the display, and the assigned Sound will be shown

in the 8-digits area. Press the Page button to enter the track edit page.

Press the Page button until you get to the RevSend or ChoSend page. The value

shown (from 00 to 15), indicates the amount of effect assigned to the track

Modify the value by rotating the DIAL

Press ESCAPE to exit

Press the STORE PERFORMANCE key for a few seconds and conﬁ rm

with ENTER to save the changes to the current Performance

Note: If you select another Performance, or recall the current one before saving the

changes, the Performance will be restored to the previously changed settings.

Page44