Use The Pedals; Transpose The Instrument; Clear The Transpose Setting - Generalmusic WK2000 SE Owner's Manual

owners manual

Use the pedals

If you have purchased the optonal Generalmusic pedals (volume and footswitch pedals), connect them to the relative
Volume and Damper pedal on the rear panel. Pedals will add the following controls:
• Damper
• Pedal
• Volume
cod. prod. 970134
cod. prod. 970116

Transpose the instrument

If you play a diffi cult tune that implies the use of many black keys, or if the tune you are playing is not in key with the
Singer's voice or with another instrument, you can transpose WK2000 SE to play in a different key.
TRANSPOSE b/# keys allow to transpose the instrument by ±12 semitones (12 semitones = 1 octave).
Press the TRANSPOSE
1
the display keyboard current tune status is shown (00 = default tuning).
Press TRANSPOSE to lower the pitch
2
Press TRANSPOSE to raise the pitch.
3
Each time the TRANSPOSE # key is pressed, the display will show an increase of one semitone. If either key is pressed and
held for some time, the transposer value changes continuously to reach the maximum value (-12 or +12) is reached.

Clear the Transpose setting

If you press both the TRANSPOSE keys at the same time, the transpose set-
tings will be cleared and the keyboard will be restored to the original neutral
(00) status.
Page8
Damper (sustain)
Switch Upper1/2, Start/Stop, Fill<, Fill^,Fill>, Intro, Ending
Master Volume
or TRANSPOSE buttons. In the central part of
cod. prod. 970013
wk2000 se
Getting Started