Aux Send; Pan; Mute / Alt 3-4; Solo - Alto S-16 User Manual

4.7.4 MID-LOW
This control gives you up to 15dB boost or cut at 500Hz.
4.7.5 LOW
This is the Bass control. Boost male voice or kickdrum and bass
guitar. Your system will sound much bigger than what it is. The
gain range goes from -15dB to +15dB and the center frequency
is 80 Hz.

4.8 AUX SEND

These two controls will send the audio signal out to Auxiliary busses.
AUX 1 can be configured as PRE/POST Fader via the PRE/POST switch:
Up for POST Fader, the audio signal will be affected by the main Channel
Fader; Down for PRE Fader, the signal is sent out before reaching the
main fader. AUX 2 is configured as POST-Fader; However, AUX 2 can
also be configure as PRE-Fader through any internal modification.
(For more detail, please see chapter 6.)
14
4.9 PAN/BAL
The PANORAMA control for the MONO channels, and BALANCE
for the STEREO channels. You can adjust the stereo image of the
signal via these Control. Keep the control in center position and
your signal will be positioned in the middle of stage. Turn the control
fully counterclockwise and the signal will be present only on the left
speaker and vice-versa. Of course a wide number of intermediate
positions is available.

4.10 MUTE / ALT 3-4

Each channel is equipped with the MUTE / ALT 3-4 switch. Pressing
this switch is used to route the channel signal to ALT 3-4 output
instead of the main mix and the LED beside MUTE/ ALT 3-4 will
illuminate.
16

4.11 SOLO

Pressing this switch allows you to monitor the signals through
signal will replace other signals, and be also sent to the CONTROL ROOM, PHONES and METERs. Usually use the
solo in live work to preview channels before they are let into the mix.
It is useful to set an instruments's input level and EQ, and you can also solo any channel that you want to. The SOLO
switch never affects any mix other than the CONTROL ROOM mix.

4.12 SOLO LED

Each channel is equipped with the SOLO LED display. When the SOLO was engaged, the LED on corresponding
channel will illuminate.
11
12
13
15
17
your headphone or CONTROL ROOM, then the SOLO
10
0 0
EQ EQ
HI HI
12kHz 12kHz
-15 +15 -15 +15
0 0
MID HI-MID
3kHz
-15 +15 -15 +15
0
800
FREQ MID-LOW
500Hz
100Hz 8kHz -15 0 +15
0
LOW LOW
80Hz 80Hz
-15 +15 -15 +15
0 0
AUX AUX
1 1
POST POST
PRE PRE
- -
+15 +15
0 0
2 2
POST POST
(PRE) (PRE)
- +15 - +15

PAN

BAL
LEFT RIGHT LEFT RIGHT
MUTE / MUTE /
ALT 3-4 ALT 3-4
SOLO SOLO
PEAK PEAK
10 10
dB dB
5 5
0 0
-5 -5
-10 -10
-15 -15
-20 -20
-30 -30
-40 -40
-60 -60
8 9/10
11
12
13
14
15
16
17
18
19