Bands Equalizer Controls; Aux Send Control; Pan/Bal Control; Peak Led - Alto AMX-100FX User Manual

4.4 3 BANDS EQUALIZER Controls

A 3-band equalizer is provided for all input channels with a wide
range of frequency adjustment.
5
-. HI
This is the Treble control. You can use it to get rid of high frequency
noises or to boost the sound of cymbals or the high harmonics of
the human voice. The gain range goes from -15dB to +15dB with
a center frequency of 12 kHz.
6
-. MID
This is the Midrange control. It can affect most fundamental fre-
quencies of all musical instruments and human voice. An attentive
use of this control will give you any very wide panorama of sound
effects. The gain range goes from -12dB to +12dB and the center
frequency is 2.5 kHz.
-. LOW 7
This is the Bass control. Boost male voice or kickdrum and bass
guitar. Your system will sound much bigger than what it is. The gain
range goes from -15dB to +15dB and the center frequency is 80 Hz.

4.5 AUX SEND Control

This control is used to adjust the level of the signal sent to AUX bus,
and its adjustable range goes from -
The AUX send is configured as POST-FADER, therefore, most of
the times, it will be used for effects and processors input, however,
you can also changed it to PRE-FADER configuration according to
the specific application. (For more detail, please see chapter 6.)

4.6 PAN/BAL Control

Abbreviation of PANORAMA control for mono channels, for the stereo channels, always says, BALANCE control.
You can adjust the stereo image of the signal via this control. Keep this control in center position and your signal
will be positioned in the middle of stage. Turn this control fully counterclockwise and the signal will be present only
on the left speaker and vice-versa.

4.7 PEAK LED

10
Inside your AMX-100(FX) the audio signal is monitored in several different stages and then sent to the PEAK LED.
When this LED blinks, it warns you that you are reaching signal saturation and possible distortion. The PEAK LED will
blink with a level that is 6dB before actual clipping.

4.8 LEVEL Control

This control will adjust the overall level of this channel and set the amount of signal sent to the main output.
8
to +15dB.
9
11
10
0
EQ
5
HI
12kHz
-15 -15 +15 +15
0
MID
6
2.5kHz
0 +12
-12
LOW
7
80Hz
-15 -15 +15 +15
0
AUX
8
POST
(PRE)
- +15
PAN
9
LEFT RIGHT
10
PEAK
11
- - +15 +15
LEVEL
1