Wiring Diagram - 3 Receivers
To Antenna
Interface Box
Destacker
To RECEIVER
2
1
Destacker (Dual-Output) Required
The dual-output destacker (KVH part #19-0410) converts a stacked signal into two
unstacked signals, which standard satellite TV receivers are configured to decode.
The interface box has two satellite TV outputs: "Unstacked" and "Stacked." You will
need to install the destacker between the "Stacked" output and your second and third
receivers.
Primary Receiver Controls Satellite Selection
The receiver that you connect to the "Unstacked" output is the primary receiver. If
the system is set up for automatic switching, the primary receiver controls satellite
selection.
INPUT
To TV
Satellite TV Receiver
TV ANT/CABLE IN
R
L
OUT TO TV
SATELLITE IN
AUDIO
VIDEO
S-VIDEO
PHONE JACK
SATELLITE IN
This receiver controls
satellite selection
Satellite TV Receivers
TV ANT/CABLE IN
R
L
OUT TO TV
SATELLITE IN
AUDIO
VIDEO
S-VIDEO
PHONE JACK
SATELLITE IN
TV ANT/CABLE IN
R
L
OUT TO TV
SATELLITE IN
AUDIO
VIDEO
S-VIDEO
PHONE JACK
SATELLITE IN
TracVision R6DX User's Guide
Appendix A - Wiring Diagrams
(Primary)
53