KVH Industries TracVision R6 DX User Manual page 32

8. Refer to the table in Figure 16 and verify the values
displayed on your TV match those required for your
selected satellite TV service.
If your values match: Exit the menu and allow the receiver to
download the program guide.
If your values do not match, and you selected Single-Sat
mode: It is normal for your TV to show "No Switch Detected,"
"Switch Type Unknown," or a similar error message. No action
is required.
If your values do not match, and you selected Dual-Sat mode:
Reset the system (follow the process on
the entire ExpressVu setup process, starting with Step 1 on
page 31.
Figure 16 Expected Check Switch Results
ExpressVu Dual-Sat Results
1
Input
91
Satellite
Odd
Polarity
Reception Verified
Status
SW21
Switch
Additional Receiver(s) - Run One Check Switch Test
If any receivers are connected to the "Stacked Output" jack on the
interface box, follow these steps to run a single Check Switch test on
each additional receiver, one at a time.
1. Temporarily disconnect the primary receiver from the
"Unstacked Output" jack on the interface box. Connect
the additional receiver in its place.
2. Perform Steps 1-5 on
3. Wait 15 minutes, then verify that the values displayed
on the TV match those shown in Figure 16. If the values
do not match, and the system is set to Dual-Sat mode,
try running another Check Switch test. If your system is
set to Single-Sat mode, an error message is expected.
1 2 2
91 82 82
Even Odd Even
page 32 to run the test.
TracVision R6DX User's Guide
Chapter 4 - Setup
page 35), then repeat
33