Table of Contents
Advertisement
Operate the following operations after activating the Zone 2
operation mode.
Operating Zone 2
Rotate the I INPUT selector to select the
desired input source while the ZONE2 indicator
is flashing in the front panel display.
• Select "TUNER" as the input source to use the TUNER
features in Zone 2. For details about the TUNER
operations, see "FM/AM tuning" on page 50.
• Select "V-AUX" as the input source to use iPod
features in Zone 2. For details about the iPod
operations, see "Using iPod™" on page 56.
y
You must complete this step within 10 seconds while the selected
zone flashes in the front panel display. Otherwise, the currently
selected zone mode is automatically canceled. In this case, press
9
ZONE CONTROL on the front panel again.
Set Zone 2 to the standby mode
Press 8 ZONE 2 ON/OFF to set Zone 2 to the
standby mode.
■ Controlling Zone 2 with the remote
control
Activating the Zone 2 operation mode
Set the operation mode selector to
SELECT k repeatedly to select the
then press
zone you want to control.
"ZONE 2" is displayed in the display window ( ) on the
remote control.
AMP
SOURCE
SELECT
TV
Turning on or off Zone 2 using the remote control
POWER and
work differently depending on the selected zone that
appears in the display window ( ) on the remote control.
• When the main zone, Zone 2 mode is selected, you can
turn on the main zone or Zone 2 or set them to the
standby mode individually.
• When the all mode is selected, pressing
turns on the main zone and Zone 2 simultaneously and
pressing
simultaneously.
Control mode
Main zone
mode
Zone 2 mode
All mode
Notes
• When the remote control is in the main zone mode, "MAIN"
appears for a few seconds when
is pressed.
AMP and
• "ALL" appears in the display window ( ) on the remote
control only when SELECT n is pressed.
Selecting the input source of Zone 2
Press one of the input selector buttons ( ) to
select the input source of the selected zone.
If the remote control is used to select the input source, "2;
name of the selected input area" is displayed in the display
window ( ) on the remote control when Zone 2 is
selected respectively.
Note
The selected input source is shared across all zones.
Using multi-zone configuration
STANDBY on the remote control
STANDBY sets them to the standby mode
Display window
(
)
Turns on the main
Name of the selected
zone only or sets it to
input area
the standby mode.
"ZONE 2" or "2;name
Turns on Zone 2 or
of the selected input
sets it to the standby
area"
mode.
on the main zone and
Zone 2.
"ALL"
the main zone and
Zone 2 to the standby
mode.
POWER or
POWER
POWER
and
STANDBY
POWER: turns
STANDBY: sets
STANDBY
97
En
Advertisement
Table of Contents
