Table of Contents
Advertisement
Optimizing the speaker setting for your listening room
■ If an error screen appears
k / n / l / h to select "RETRY" or
Press
"EXIT" and then press
The following display is an example where "E-9:USER
CANCEL" appears in the OSD.
AUTO:ERROR
. E-9:USER CANCEL
Don't operate
any function.
>RETRY
[
[ ]/[ ]:Select
[ENTER]:Enter
Choices: RETRY, EXIT
• Select "RETRY" to retry the "AUTO SETUP"
procedure.
• Select "EXIT" to exit from the "AUTO SETUP"
procedure.
■ If "WARNING" appears
When this unit detects potential problems during the
"AUTO SETUP" procedure, "WARNING" appears in the
"AUTO:RESULT" display. Check the warning messages
to correct your speaker settings.
Note
Warnings differ from errors in that warnings do not cancel the
"AUTO SETUP" procedure.
1
Make sure the pointer is pointing at
"WARNING" and then press
display the detailed information about the
warning.
The number on the right of "WARNING" indicates
the number of warning messages.
AUTO:RESULT
. WARNING(3)
RESULT
SP
DIST: 4.50/5.30m
LVL : -9.0/+6.5dB
>SET
[ ]/[ ]:Up/Down
[ENTER]:Enter
32
En
.
EXIT
[
to
:
3/4/0.1
CANCEL
2
l / h repeatedly to toggle between
Press
the warning displays.
WARNING:W-1
<OUT OF PHASE>
Reverse Channel
FL
CENTER
PL
SL
SBL
[
[ ]/[ ]:Select
[ENTER]:Return
y
• For details about each warning message, see the "AUTO
SETUP" section in "Troubleshooting" on page 107.
• When the corresponding warning message is not
applicable to a speaker, "– –" is displayed instead.
3
Press
to return to the top
"AUTO:RESULT" display.
--
PR
SR
SBR
[
Advertisement
Table of Contents
