M8 Nylon; M10 Nylon; Pulley - ProForm 630 Weight Bench User Manual

12. Press a 2Ó Square Inner Cap (17) into each end of
the Leg lever (18).
Insert the Weight Tube (39) into the indicated hole in
the Leg Lever (18). Attach the Weight Tube to the Leg
Lever with the M8 x 62mm Bolt (66), the 13mm
Spacer (43), two M8 Washers (23) and an M8 Nylon
Locknut (13).
Press a 1Ó Round Inner Cap (12) into the indicated
end of the Weight Tube (39). Press the Angle Cap
(49) onto the indicated end of the Weight Tube.
Note: The above steps may have been pre-assem-
bled.
Slide a Weight Stop (62) onto the Weight Tube.
13. Lubricate the M10 x 72mm Bolt (59).
Attach the Leg Lever (18) to the bracket (H) on the
Front Leg (19) with the M10 x 72mm Bolt (59) and an
M10 Nylon Locknut (1).
Do not overtighten the Nylon Locknut. You must
be able to freely pivot the Leg Lever.
14. Press a 3/4Ó Round Inner Cap (54) into each end of
the three Pad Tubes (46 and 48).
Insert a Short Pad Tube (48) through the upper hole
in the Leg Lever (18). Slide two Foam Pads (10) onto
the Pad Tube.
Insert the Long Pad Tube (46) through the lower hole
in the Leg Lever (18). Slide two Foam Pads (10) onto
the Pad Tube.
Insert a Short Pad Tube (48) through one set of holes
in the bracket (H) on the Front Leg (19). Slide two
Foam Pads (10) onto the Pad Tube.
15. Feed the Cable (45) through the Pulley Bracket (60)
as shown.
Rest the Cable (45) in the groove of a Pulley (35).
Attach the Pulley to the Pulley Bracket (60) with an
M10 x 63mm Bolt (33), two M10 Washers (6), two
Pulley Spacers (61) and an M10 Nylon Locknut (1).
Rest the Cable (45) in the groove of the second
Pulley (35). Attach the Pulley to the Pulley Bracket
(60) as described above. Make sure the Cable (45)
runs smoothly over both Pulleys (35).
Attach the Cable Clip (40) to the Cable (45).
12
17
39
12
H
13
1
18
14
10
54
18
10
48
15
33
6
35
10
17
18
23
49
13
43
23
17
62
19
59
Lubricate
19
H
48
54
54
46
54
61
61
6
1
60
66
10
35
45
40