Advertisement
Wall mounting
If wall mounting your BT On-Air 1100 Classic,
use this guide for position.
•
Make sure that you are not drilling into any
hidden wiring and check that the power
cable will reach from the mains socket to
the charger. Switch the power adaptor off at
the mains and remove the adaptor plug
from its socket.
•
Drill two holes 25mm deep using a 3mm
drill, 122mm apart to take the wall plugs.
•
Put wall plugs into the drill holes and then
insert both screws. Leave 2-3mm between
the head of the screw and the wall. You are
now able to mount the base to the wall.
•
Fit the base onto the two screws.
If necessary, tighten or loosen the screws
for the best fit.
•
Put the handset back in the base and switch
the power back on at the wall socket.
15
SCREW
WALL PLUG
WALL
122 mm
Advertisement
