Attaching And Removing Shank; Seam Allowance Lines; Controlling Sewing Speed - ELNA 6200 Instruction Manual

q
w

Attaching and Removing Shank

Turn OFF the power switch. Raise the presser bar. Turn
the thumbscrew q counterclockwise with the screwdriver
to remove the shank.
To attach, match the hole in the shank w with the hole in
the presser bar e. Put thumbscrew in hole and turn
clockwise to tighten.
e

Seam Allowance Lines

q
The lines on the needle plate, machine bed and bobbin
cover plate help you measure seam width. The number
w
indicates the distance between the center needle
position (3.5) and the seam allowance line.
q
w
e
r
e
r

Controlling Sewing Speed

Sewing speed can be varied with the foot control. The
harder you press on the foot control, the faster the
machine runs.
The maximum sewing speed can be varied by sliding the
speed control lever. For a faster speed, slide it to the
right; for a slower speed, slide it to the left.
9
Center needle position
Edge of fabric
Guidelines
90º pivot angle guideline for 5/8˝