Raising And Lowering The Presser Foot; Changing The Presser Foot; Removing And Attaching The Shank - ELNA 2600 Instruction Manual

e
w
q
e
w
q
e
e
w
q
w
r
7

Raising and Lowering the Presser Foot

The presser foot lever raises and lowers the presser
foot.
You can raise the foot about 1/4" (0.6 cm) higher than
the raised position for easy removal of the presser foot,
or to place heavy fabric under the foot.
q Lowered position
w Raised position
e Extra high position

Changing the Presser Foot

To remove:
Raise the needle to its highest position by turning the
flywheel counterclockwise. Raise the presser foot, and
press the lever on the back of the shank.
q Lever
CAUTION:
Turn OFF the power switch before changing the foot.
Always use the proper foot for the selected stitch.
The wrong foot can cause the needle to break.
Do not push the lever down to prevent it from being
broken.
To attach:
Place the desired presser foot, so that the pin on the foot
lies just under the groove on the shank. Lower the
presser foot lever to lock the foot in place.
w Groove
e Pin

Removing and Attaching the Shank

WARNING:
Turn OFF the power switch before detaching or
attaching the shank.
To remove:
Remove the setscrew by turning it counterclockwise with
a screwdriver and remove the shank.
To attach:
Match the hole in the shank with the threaded hole in the
presser bar. Fit the setscrew into the hole. Tighten the
screw by turning it clockwise with a screwdriver.
q Setscrew
w Shank
e Hole
r Threaded hole