Troubleshooting Fault Displays - Electrolux EWT959 User Manual

Troubleshooting fault displays

Fault information and a guide for when you should call for service
The following messages appear on the LCD screen of your washing machine if a problem has been diagnosed.
Fault Display messages are shown on the left hand display screen.
The machine cannot fill.
Please turn on wall taps
and then press
START/PAUSE. The
machine will then resume
operation
Flood. Is there water
pouring into the bowl?
YES --> Turn off wall taps
and machine. Call Service.
self-clear
Draining difficulty
The machine cannot do a
wash. Call Service
The motor cannot run.
Select DRAIN&SPIN and
press START/PAUSE
to drain water from bowl,
then call Service.
OR
The motor cannot run.
Select DRAIN&SPIN to
drain water from bowl,
then call Service.
Level sensor fault.
Select DRAIN&SPIN and
press START/PAUSE to
drain water from bowl,
then power down, then
call Service.
Cannot agitate.
Select DRAIN&SPIN and
press START/PAUSE to
drain water from bowl,
then call Service.
Should you require further instructions in the care and use of your washing machine please contact Customer Care on the
numbers shown on the back page.
electrolux water aid washing machine troubleshooting fault displays 19
Beeping Problem
Not filling with
continuously water
continuously turning off
5 secs in draining
every correctly
10 secs
Control panel
5 secs in not functioning
every 10 secs properly
Faults related to
5 secs in motor & drive
every 10 secs system
continuously sensor not
operating
correctly
Recirculation
5 secs in pump fault
every 10 secs
Action to take
Make sure both wall taps are on, and hose filters not
blocked.
Raise drain hose if water flowing out of drain hose.
Press Start/Pause to re-start wash.
If problem remains, call Service.
If water is pouring onto the floor, turn both wall taps
not, call Service.
The pump will switch off and on repeatedly to clear any
blockage.
If not, press Start/Pause then check the drain hose for
blockage. Press Start/Pause to continue wash.
If problem remains, call Service.
Press Power button to turn machine off machine.
Restart the machine.
If problem still exists, call Service.
If not, select DRAIN&SPIN to drain water from bowl. You
may have to press Start/Pause to commence draining.
If this problem is repeatedly experienced, call Service.
The machine will only permit draining.
Select DRAIN&SPIN, then press Start/Pause to drain
water from machine.
call Service.
If this problem is repeatedly experienced, call Service.