Starting Your Washing Machine; Choosing Your Own Wash Program Settings; Fabric Button; Dirt Level Button - Electrolux EWT959 User Manual

Operating your washing machine

Starting your washing machine

1. Turn on the taps
2. Close the lid
The machine will 'beep' twice, show a welcome message
for a short time and then it is ready for you to select the
wash program settings.
The screens should look something like these:
NOTE: On powering up the machine, some settings will reset
to a default condition. DELAY and SOAK reset to zero (0)
while the WATER level resets to AUTO.
If the displayed settings are what you want to use, press the
Start/Pause button to start the wash.
Alternatively you can,
To find out more about these options read the instructions
on the following pages.

Choosing your own wash program settings

there will be a short delay of 2 seconds before a change
to settings takes effect. This is to allow you time to
complete your desired changes.
progress of the wash may not continue exactly from
where it was in the program before the change.
selection you make is unavailable at the time, you will
hear a long 'error beep'.

Fabric button

The Fabric button is used to select the
appropriate wash program for your load.
Press the Fabric button repeatedly until
you see the program you want in the left
hand display screen.
The table on page 8 gives you guidance for
your wash program and for the other selections
available to you using the Fabric button.
The other selections you can make using
the Fabric button are RINSE&SPIN only
and DRAIN&SPIN only.
electrolux water aid washing machine operating your washing machine 7
program, DEEP RINSE is automatically selected for you.
You cannot use Eco RINSE with these wash programs.

Dirt Level button

For the same wash program, MORE DIRTY will have a
longer wash time than DIRTY, and DIRTY a longer wash
time than LESS DIRTY.

Water Aid recirculation system active programs

Your machine is programmed with the recirculation system
active in most wash and deep rinse stages of the various
wash programs.
The following table shows when the recirculation is active
during wash and deep rinse, for the different settings of
Is the recirculation system active?
Dirt Level
Wash Program
(Fabric button)
Heavy Duty
Colours
Delicates
Handwash
NOTE: Eco Rinse
With most programs you have an option of selecting an Eco
Rinse, in which case the Deep Rinse column of the table above
is not relevant. Recirculation is not active during Eco Rinse.
tips and information
eg. very dirty work clothes and overalls.
family clothes, sheets etc.
just to freshen them up.
Press the Dirt Level button repeatedly until
the level you want is shown in the left hand
display screen.
The Dirt Level option chosen will have an
influence on the wash time of the selected
wash program.
Less Dirty
Deep
Rinse
No No
Yes Yes
No Yes
Yes Yes
Yes Yes
Yes Yes
Dirty More Dirty
Deep Deep
Rinse Rinse
No No No No
No
Yes Yes Yes
No Yes No No
Yes Yes No Yes
Yes Yes No Yes
Yes Yes No Yes