Troubleshooting Fault Displays; Model: Ewt959 - Electrolux EWT806 User Manual

Troubleshooting fault displays

Model: EWT959

Fault information and a guide for when you should call for service
The following messages appear on the LCD screen of your washing machine if a problem has been diagnosed.
Fault Display messages are shown on the left hand display screen.
The display is accompanied by 'Beeping' as shown in the Beeping column.
Fault display – left screen
The machine cannot fill.
Please turn on wall taps
and then press
START/PAUSE. The
machine will then resume
operation
Flood. Is there water
pouring into the bowl?
YES --> Turn off wall taps
and machine. Call Service.
NO --> Wait for this fault to
self-clear
Draining difculty
The machine cannot do a
wash. Call Service
The motor cannot run.
Select DRAIN&SPIN and
press START/PAUSE
to drain water from bowl,
then call Service.
OR
The motor cannot run.
Select DRAIN&SPIN to
drain water from bowl,
then call Service.
Level sensor fault.
Select DRAIN&SPIN and
press START/PAUSE to
drain water from bowl,
then power down, then
call Service.
electrolux water aid washing machine troubleshooting fault displays 31
Beeping Problem Action to take
Beeping Not filling with Make sure both wall taps are on, and hose filters not
continuously water blocked.
Raise drain hose if water owing out of drain hose.
Press Start/Pause to re-start wash.
If problem remains, call Service.
Beeping Water is not If water is pouring onto the floor, turn both wall taps
continuously turning off OFF. Wait a few minutes to see if fault is corrected - if
not, call Service.
Beeping Water not The pump will switch off and on repeatedly to clear any
5 secs in draining blockage.
every correctly
Wait a few minutes to see if the fault is corrected.
10 secs
If not, press Start/Pause then check the drain hose for
blockage. Press Start/Pause to continue wash.
If problem remains, call Service.
Beeping Control panel Press Power button to turn machine off machine.
5 secs in not functioning Restart the machine.
every 10 secs properly
If problem still exists, call Service.
Beeping Faults related to Wait, the problem may self clear.
5 secs in motor & drive
every 10 secs system
If not, select DRAIN&SPIN to drain water from bowl. You
may have to press Start/Pause to commence draining.
If this problem is repeatedly experienced, call Service.
Beeping Water level The machine will only permit draining.
continuously sensor not
Select DRAIN&SPIN, then press Start/Pause to drain
operating
water from machine.
correctly
When empty, press Power to switch off machine and
call Service.
EN