Troubleshooting Fault Displays - Electrolux EWT606 User Manual

Troubleshooting fault displays

Fault information and a guide for when you should call for service
If you have a problem with your washing machine and before you call service, make sure you have followed ALL of the
instructions that may remedy the problem. You will find instructions in the 'Troubleshooting' section on pages 17 and 18
and in the table below.
Fault information and the action you should take are described in the following table.
Digital display Problem
fault code
Not filling with water
Recirculation pump
fault
correctly.
operating correctly.
Control panel not
functioning properly.
Motor fault
Should you require further instructions in the care and use of your washing machine please contact Customer Care on the
numbers shown on the back page.
electrolux water aid washing machine troubleshooting fault displays 19
Action to take
Make sure both wall taps are on, and hose filters not blocked.
Raise drain hose if water flowing out of drain hose.
Press Start/Pause to re-start wash.
If problem remains, call Service.
fault is corrected - if not, call Service.
Press Start/Pause to start the pump. After 30 seconds the machine will commence
agitation.
If problem repeats, advance to rinse or spin to drain machine. Call Service.
The drain pump will switch off and on repeatedly to clear any blockage.
If not, press Start/Pause then check the drain hose for blockage. Press Start/Pause to
continue wash.
If problem remains, call Service.
The machine will only permit draining. If not draining, press Advance to select spin stage,
then press Start/Pause to start pump.
If this problem is repeatedly experienced, call Service.
Press Power button to turn machine off. Restart the machine.
If problem still exists, call Service.
If not, select Spin to drain water from bowl.
You may have to press Start/Pause to commence draining.
If this problem is repeatedly experienced, call Service.