Error Message - Samsung SCX-4200 Series Service Manual

4.10 Error Message

Display
Door Open The front cover is not securely latched.
Hsync Error A problem has occurred in the LSU
(Laser Scanning Unit).
[Invalid There is invalid foner install.
Cartridge]
Low Heat Error There is a problem in the fuser unit.
[LSU Error] A problem has occurred in the LSU
(Laser Scanning Unit).
[No Paper] The paper in the paper input tray has run
Add Paperr out.
Open Heat Error There is a problem in the fuser unit.
[Over Heat] There is a problem in the fuser unit.
[Paper Jam 0] Paper has jammed in the feeding area
Open/Close of the paper input tray.
Door
[Paper Jam 1] Paper has jammed in the fuser area or
Open/Close in the manual feeder.
Door
[Paper Jam 2] Paper has jammed in the paper exit area.
Check Inside
Power Failure Power has turned off then on and the
machine's memory has not been back up.
Scanner Error There is a problem in the scanner unit.
Samsung Electronics
Meaning
Alignment and Adjustmens
Suggested solutions
Close the cover until it locks into place.
Unplug the power cord and plug it back in. If the
problem persists, please call for service.
Installed authorized toner cartridge.
Unplug the power cord and plug it back in. If the
problem persists, please call for service.
Unplug the power cord and plug it back in. If the
problem persists, please call for service.
Load paper in the paper input tray.
Unplug the power cord and plug it back in. If the
problem persists, please call for service.
Unplug the power cord and plug it back in. If the
problem persists, please call for service.
Clear the jam.
Clear the jam.
Clear the jam.
The job which you were trying to do before the
power failure must be completely re-done.
Unplug the power cord and plug it back in. If the
problem persists, please call for service.
Service Manual
4-9