Disassembly and Reassembly
5.10 Fuser
1. Before you remove the Fuser, you should remove:
- Rear Cover (Refer to 5.3)
2. Unplug the two connectors from the Main PBA and
SMPS, as shown below.
3. Remove the four screws securing the Fuser and
remove it.
Notice: Remove the Fuser taking care not to damage
the Exit Sensor.
Service Manual
5-12
4. Remove the two screws securing the Thermostat and
then release the Fuser Harness and Fuser Joint
Harness from both side of the Thermostat, as shown
below. Then take the Thermostat out of the Fuser.
Fuser Joint Harness
5. Remove the two screws securing the Halogen Lamp
and then release the Fuser Harness and Fuser Joint
Harness from both side of the Halogen Lamp, as
shown below. Then take the Halogen Lamp out of the
Heat Roller.
Fuser
Thermostat
Heat Roller
Halogen Lamp
Samsung Electronics
Fuser Harness