Consumables And Replacement Parts; The Lcd Status Display By Each Error - Samsung SCX-4200 Series Service Manual

4.7 Consumables and Replacement Parts

The cycle period outlined below is a general guideline for maintenance.
The example list is for an average usage of 50 transmitted and received documents per day.
Environmental conditions and actual use will vary these factors.
The cycle period given below is for reference only.
COMPONENT
Pick-up Roller
Paepr Feeding Roller(Friction Pad)
Transfer Roller
Fuser
Toner Cartridge

4.8 The LCD Status Display by Each Error

LCD
Door Open
[JAM 1] or
[No Cartridge]
Low Heat Error
Open Heat Error
[Over Heat]
[LSU Error]
No Paper
[Add Paper]
Paper Jam 0
Open/Close Door
Paper Jam 1
Open/Close Door
Paper Jam 2
Check Inside
Samsung Electronics
Meaning
The front or rear cover is not securely
latched.
The toner cartrige is not installed.
There is a problem in the fuser unit.
A problem has occurred in the LSU
(Laser Scanning Unit).
The paper tray has run out of paper.
Paper has jammed in the feeding area of
the paper tray.
• Paper has jammed in the fuser area.
• A paper jam has occurred in the manual
feeder or the machine detects non-
feeding from the manual feeder.
Paper has jammed in the paper exit area.
REPLACEMENT CYCLE
50,000 Pages
50,000 Pages
50,000 Pages
50,000 Pages
Original 1,000 Pages
Close the cover until it locks into place.
Install the toner cartridge.
Unplug the power cord and plug it back in.
(Tech Mode Reference)
Unplug the power cord and plug it back in.
(Tech Mode Reference)
Load paper in the paper tray.
Clear the jam.
• Clear the jam.
• Clear the jam.
Clear the jam.
Alignment and Adjustmens
Replacement 3,000 Pages
Solutions
Service Manual
4-7