Direct Playback; Pure Direct Playback - Denon AVR-X3000 Owner's Manual

Contents

Direct playback

Sound recorded in source is played as is.
1
Press PURE to select "DIRECT".
Direct playback begins.
%
• While DSD signals are played back, "DSD DIRECT" is displayed.
Front panel Display
Connections Playback
Rear panel
Settings

Pure Direct playback

This mode is for playback with higher sound quality than in "DIRECT"
mode, by turning off the front panel display panel, which can eliminate
faint low level noise from creeping into sensitive analog circuitry.
1
Press PURE to select "PURE DIRECT".
The display goes dark, and Pure Direct playback begins.
%
• In DIRECT and PURE DIRECT sound modes, the following items cannot be
adjusted.
• Tone (vpage 134)
• Restorer (vpage 134)
• MultEQ® XT (vpage 136)
• Dynamic EQ (vpage 136)
• Dynamic Volume (vpage 137)
NOTE
• Video signals are only output when HDMI signals are played in the PURE DIRECT
mode.
• When the PURE DIRECT mode has been selected, the display turns off after about
5 seconds.
100
Remote
Tips Appendix
Index