Direct Playback - Denon AVR-X2000 Owner's Manual

Contents

Direct playback

Sound recorded in source is played as is.
1
Press PURE to select "DIRECT".
Direct playback begins.
Front panel Display
Connections Playback
Rear panel
Settings
Pure Direct playback
This mode is for playback with higher sound quality than in "DIRECT"
mode, by turning off the front panel display panel, which can eliminate
faint low level noise from creeping into sensitive analog circuitry.
1
Press PURE to select "PURE DIRECT".
The display goes dark, and Pure Direct playback begins.
%
• In DIRECT and PURE DIRECT sound modes, the following items cannot be
adjusted.
• Tone (vpage 126)
• Restorer (vpage 126)
• MultEQ® XT (vpage 128)
• Dynamic EQ (vpage 128)
• Dynamic Volume (vpage 129)
NOTE
• Video signals are only output when HDMI signals are played in the PURE DIRECT
mode.
• When the PURE DIRECT mode has been selected, the display turns off after about
5 seconds. The power indicator will remain lit (green). To restore the display press
PURE again, which will set the unit in DIRECT mode.
96
Remote
Tips Appendix
Index