Battery Discharge Indicator Troubleshooting; Chariot Ivac - Windsor Chariot 2 iVac 24 ATV CV2410125760 Operating Instructions Manual

Table of Contents

Advertisement

Battery Discharge Indicator Troubleshooting

The battery indicator flashes when a problem occurs. The table below list solutions for the indicated problems.
Number of
flashes
The battery needs charging, there is a bad connection to
the battery or dependent on the programming, may
1
indicate that the battery lockout function is active and the
controller is in a restricted mode of operation. Check the
connections to the battery.
There is a bad connection to the drive motor.
2
The drive motor has a short circuit to a battery connection. Contact your service agent.
3
The battery charge level has fallen below the battery
4
Lockout Level and the controller is inhibiting brush and
vacuum functions
5
Not used.
The controller is being inhibited from driving, this may be
6
because the battery charger is connected (on board
charger only).
A throttle fault is indicated.
7
A controller fault is indicated.
8
The parking brake has a bad connection.
9
An excessive voltage has been applied to the controller.
10
This is usually caused by a poor battery connection.
-
Blinks once every 5 seconds
Problem

86349370 Chariot iVac 24

Maintenance
Solution
If the connections are good, try
charging the battery.
Check all connections between the
motor and the controller.
Charge the battery.
-
Disconnect battery charger.
Make sure that the throttle is in the
rest position before switching on the
machine.
Make sure that all connections are
secure.
Check the parking brake and motor
connections. Make sure the
controller connections are secure.
Check the battery connections.
Sleep mode, cycle key switch
41

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Chariot 2 ivac 24 atv cvc2410125770

Table of Contents