Troubleshooting - Windsor Chariot 2 iVac 24 ATV CV2410125760 Operating Instructions Manual

Troubleshooting

PROBLEM
No machine function
No power to machine
Little or no propel
Machine does not
change speeds
Forward speed only
Reverse speed only
Battery indicator light
flashing
CAUSE
Console lid is open
Battery disconnected
Emergency shut-off activated
Battery cables corroded
Faulty key switch
Batteries not plugged in
On Board charger plugged in
Low battery charge
Tripped circuit breaker
Machine turned on with pedal not in neutral
position
Controller protecting motor from overload
Machine is stalled against an obstacle
(threshold, curb, etc.)
Controller overheated
Loose motor connection
Faulty throttle circuit or potentiometer
Faulty drive reset circuit or switch
Faulty platform circuit or switch
Brake over-ride engaged
Faulty brake circuit or over-ride switch
Drive Lever disengaged
Faulty speed control circuit or switch
Faulty forward/reverse circuit
Battery needs charged
Controller is indicating a fault code
86349370 Chariot iVac 24
Maintenance
SOLUTION
Close console lid
Check all battery cable connections
Reset
Clean connections
Replace switch
Plug batteries in
Un-plug and stow cord
Charge batteries
Reset controller circuit breaker
Allow pedal to return to neutral. Restart
Controller limits motor amperage. Allow
unit to cool down for several minutes.
Remove obstacle or push machine away
from obstacle
Allow cool down period
Check wires and connections from
controller to motor
Check wires and connections from and
potentiometer resistance
Check wires, connection and switch
Check wires, connections and switch
Disengage brake over-ride
Check wires, connections and switch
Engage drive
Check wires & connections
Check wires & connections
Charge Battery
See fault code table
39