Table of Contents
Advertisement
2.7.2 Jumpers
1. 32-bit PCI Gigabit Ethernet setting (3-pin J9)
These jumpers are set by default, pins [1-2], to enable the onboard
Gigabit Ethernet controller to support 10/100/1000BASE-TX networks.
Set the jumper to pins [2-3] to disable the controller.
NRL-LS/533
NRL-LS/533 Gigabit Ethernet Setting
2. VGA setting (3-pin J3)
This jumper is set by default, pins [2-3], to enable the VGA controller.
Set to pins [1-2] to disable the VGA controller.
NRL-LS/533
NRL-LS/533 VGA Setting
2-16
®
1
2
Enable
(Default)
®
1 2
Disable
J9
2
3
Disable
J3
2 3
Enable
(Default)
Chapter 2: Hardware information
Advertisement
Table of Contents
