Table of Contents
Advertisement
4. Novell NetWare Server
I. ADAPTEC SCSI Driver Installation
A single driver (*HAM) is provided for the Novell NetWare 4.XX, and 5.X
environments. This document explains how to install and use Adaptec SCSI
Host Adapter Module (HAM) driver for NetWare. The Adaptec solution that
consists of the device drivers ADPT160M.DDI and ADPT160M are Host
Adapter Modules (HAMs). HAM. To support SCSI devices, load the HAM in
conjunction with a SCSI Custom Device Module (CDM). Novell has developed
generic CDMs to support SCSI-2 hard drives, SCSI CD-ROM devices, SCSI
Magneto Optical devices, SCSI tape devices, and SCSI changer devices. In
addition, third party vendors are developing CDMs to support their specific
devices. Novell Netware does not include the drivers for the Adaptec SCSI
controller. You must create a driver disk prior to Novell Netware installation.
NOTE: Prepare one blank formatted high density floppy disk. Label the disk
"Ultra160 FMS v1.11 for Novell Netware version 3.1x/4.xx Setup Disk" or
"Ultra160 FMS v1.11 for Novell Netware version 5.xx Setup Disk".
A. Preparing an Adaptec Driver Disk
1. Insert the ASUS support CD into your CD-ROM drive.
2. Run the Adaptec Disk Creation Utility from the following path:
\Drivers\Adaptec\fmsutil.exe
3. Select Ultra160 FMS 1.11 from the options that appear. Press Enter to display
the following.
ASUS NRL-LS533 motherboard user guide
5-13
Advertisement
Table of Contents
