Table of Contents
Advertisement
4. Select SCO UnixWare 2.1x, 7.x, OpenServer 5.0.x. Press Enter.
5. Select either "SCO UnixWare 2.1x" or "SCO UnixWare 7.x" or "SCO
OpenServer 5.0.x". Press Enter.
6. When prompted, insert the floppy disk that you labeled "Ultra160 FMS
v1.11 for SCO UnixWare 2.1x Setup Disk" or "Ultra160 FMS v1.11 for
SCO UnixWare 7.x Setup Disk" or "Ultra160 FMS v1.11 for SCO
OpenServer 5.0.x Setup Disk".
7. Press Enter and follow the succeeding screen instructions.
Where: SLOT=x Specifies the NBI (NetWare Bus Interface) slot number.
Substitute x with the valid value for the adapter. You will be prompted with the
slot number(s) of installed PRO/100+ adapters. The NBI numbers are different
from the slot number indicated in the SETUP.EXE utility. NET=xxxxxxxx is
the unique network address for that LAN segment. The default frame type is
802.2. If your workstation needs to use the 802.3 frame type, see the section
later in this document about using multiple frame types on one adapter.
5-20
Chapter 5: Driver Installation
Advertisement
Table of Contents
