Punching Holes In Copies (Punch Settings) - Konica Minolta BizHub C352 User Manual

Punching holes in copies (Punch settings)

In order for holes to be punched in the copies, all of the following conditions must be met.
The paper width must be between 182 mm and 297 mm.
The paper length must be between 182 mm and 432 mm.
If a Punch setting is to be selected, select the orientation in which the original is
positioned. If an Original Direction setting is not selected, holes may not be punched
in the copies as desired.
For details on specifying the original orientation, refer to "Selecting the original
orientation (Original Direction settings)" on page 4-23.
To punch holes in copies
1. In the Basic screen, touch [Finishing]. The Finishing screen appears.
2. Touch [4holes].
To cancel the Punch setting, touch [4holes] again to deselect it.
To cancel changes to the settings, touch [Cancel].
3. Touch [Position].
Touch the button for the desired position, and then touch [OK].
Touch [Auto] to automatically determine the position of the punched holes according
to the orientation of the loaded original. If the original length is 297 mm or less, the
holes are punched along the long side of the paper. If the original length is more than
297 mm, the holes are punched along the short side of the paper.
If "Auto" is selected, the punched hole position is set at the top or at the left.
To cancel changes to the punched hole position, touch [Cancel].
To specify the output tray, touch the button for the desired tray under "Output Tray".
4. Touch [OK]. The Basic screen appears again.
BizHub C352 User Guide
20