Icom IC-M604 Instruction Manual page 58

9
CONNECTIONS AND MAINTENANCE
q Insert the supplied cable (or HM-157 without the cable)
into the [COMMAND MIC-1] or [COMMAND MIC-2] con-
nector and tighten the cable nut as shown below.
• Up to two COMMANDMIC™s can be connected simultaneously.
• The HM-157 and HM-162 can be used together.
[COMMAND MIC-1]
w To use the supplied cable as a wall socket, perform the fol-
lowing steps.
e Using the mounting base as a template, carefully mark the
holes where the cable and three screws will be fastened.
r Drill holes at these marks.
52
t Install the mounting base using the supplied screws as
[COMMAND MIC-2]
Screw holes
(approx. 2 (d) mm;
shown below.
• HM-157
Mounting base
Gasket
Screw holes
(approx. 2 (d) mm; 3 32
• HM-162
Mounting base
Gasket
)
3 32
Nut
Cap
)
Completed
Nut
Cap
Completed