I Setting Tag Channels; Scan Operation; I Starting A Scan - Icom IC-M604 Instruction Manual

I Setting TAG channels

For more efficient scanning, add the desired channels as TAG
channels or clear the TAG for unwanted channels.
Channels that are not tagged will be skipped during scanning.
TAG channels can be assigned to each channel group
(U.S.A., International and Canada) independently.
q While pushing and holding [H/L], push [CH/WX] several
times to select the desired channel group.
w Select the desired channel to be set as a TAG channel.
e Push [F], then push [5•
TAG
as a TAG channel.
• " " appears in the display.
r To cancel the TAG channel setting, repeat step e.
• " " disappears.
Clearing (or setting) all tagged channels
While pushing and holding [H/L], push [5•
(until a long beep changes to 2 short beeps) to clear all TAG
channels setting in the selected channel group.
• Repeat above procedure to set all channels as TAG channels.
[Example]: Starting a normal scan.
] to set the displayed channel
TAG ] for 3 sec.
Push
then push

I Starting a scan

Set scan type (Priority or Normal scan) and scan resume
timer in advance using Set mode. (p. 43)
q While pushing and holding [H/L], push [CH/WX] several
times to select the channel group, if desired.
w Set TAG channels as described at left.
e Make sure the squelch is closed to start a scan.
r Push [F], then push [4•
scan.
• " " or "
• When a signal is detected, scan pauses until the signal disap-
pears or resumes after pausing 5 sec. according to Set mode
setting. (Channel 16 is still monitored during Priority scan.)
• Rotate [SELECTOR] or push [Y Y ]/[Z Z ] on the microphone to
check the scanning TAG channels, to change the scanning di-
rection or resume the scan manually.
• A beep tones sounds and "
on Channel 16 during Priority scan.
t To stop the scan, push [CLR] or repeat step r.
Scan starts.

SCAN OPERATION

] to start Priority or Normal
SCN
" appears in the display.
" blinks when a signal is received
When a signal is received
5
5
15