Set Mode; I General Set Mode - Icom IC-7400 Instruction Manual

I General set mode

D D Entering set mode
Set mode is used for programming infrequently
changed values or conditions of functions.
• Set mode operation
q Push [MENU] several times to select the function
menu indication, if necessary.
w Push [MENU] for 1 sec. to enter the set mode.
e Push [F1 ≤] or [F2 ≥] to select the desired item.
r Set the desired condition using the tuning dial.
• Push [F3] for 1 sec. to select a default condition or value.
t Push [MENU] to exit the set mode.
D D Set mode items
1.
This item adjusts the contrast of the LCD from 0% to
100% in 1% steps.
(default: 50%)
2.
This item adjusts the brightness of the LCD from 0%
to 100% in 1% steps.
(default: 50%)
3.
This item adjusts the volume level for confirmation
beep tones from 0% to 100% in 1% steps. When the
beep tones, item 6.
this setting has no effect.
(default: 50%)
4.
This item allows you to set a maximum volume level
for confirmation beep tones. Confirmation beep tones
are linked to the [AF] control until a specified volume
level is reached— further rotation of the [AF] control
will not increase the volume of the beep tones.
Confirmation beep ON (default)
Confirmation beep OFF
5.
This item is used for a simple frequency check of the
transceiver.
Calibration marker ON
Calibration marker OFF (default)
See p. 93 for calibration procedure.
(p. 81), are turned OFF,

SET MODE

[F1 ≤] [F2 ≥]
[MENU]
Turn the calibration marker OFF after checking the
frequency of the transceiver.
11
Tuning dial
80