Completing The Installation - IBM System x3250 M4 Installation & User Manual

3. Slide the hot-swap power supply into the bay until the release latch clicks into
4. Connect one end of the power cord for the new power supply into the ac
5. If the server is turned off, turn on the server.
6. Make sure that the ac power LED on the power supply is lit, indicating that the
7. If you are adding a power supply to the server, attach the redundant power

Completing the installation

To complete the installation, complete the following steps:
place.
connector on the back of the power supply; then, connect the other end of the
power cord into a properly grounded electrical outlet.
power supply is operating correctly. If the server is turned on, make sure that
the dc power LED on the power supply is lit also.
information label that comes with this option on the server top cover near the
power supplies.
Power
supply
filler
Power
supply
Power
supply
release tab
Chapter 2. Installing optional devices
45