Replacing The Pci Riser-Card Assembly - IBM System x3250 M4 Installation & User Manual

1. If you removed the PCI riser-card assembly, replace it (see "Replacing the PCI
2. If you removed the air baffle, replace it (see "Replacing the air baffle" on page
3. If you removed the server top cover, replace it (see "Replacing the server top
4. Install the server in the rack cabinet (see the Rack Installation Instructions that
5. Reconnect the cables and power cords (see "Connecting the cables" on page
6. Update the server configuration (see "Updating the server configuration" on
7. Slide the server back into the rack, if necessary.
8. (IBM Business Partners only) Complete the additional steps in "Instructions for

Replacing the PCI riser-card assembly

To install the PCI riser-card assembly, complete the following steps:
1. Read the safety information that begins on page "Safety" on page vii and
2. Install the adapters in the riser-card assembly (see "Installing an adapter" on
3. Reconnect any adapter cables that you disconnected when you removed the
4. Carefully align the PCI riser-card assembly with the guides on the rear of the
5. Install the server top cover (see "Replacing the server top cover" on page 47).
6. Slide the server into the rack.
7. Connect the cables and power cords.
8. Turn on all attached devices and the server.
46
IBM System x3250 M4 Type 2583: Installation and User's Guide
riser-card assembly").
47).
cover" on page 47).
come with the server for instructions).
48).
page 49).
IBM Business Partners" on page 17.
"Installation guidelines" on page 25.
page 39).
PCI riser-card assembly.
server and with the PCI riser-card connector on the system board; then, place
your thumbs on locations marked by the blue dots and press down on the PCI
riser-card assembly. Make sure that the riser-card assembly is fully seated in
the connector on the system board.
Riser-card
assembly