Installing A Hot-Swap Power Supply - IBM System x3250 M4 Installation & User Manual

10. Reinstall the riser-card assembly in the server (see "Replacing the PCI
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 45.
Note: When you restart the server, you are prompted to import the existing RAID

Installing a hot-swap power supply

The following notes describe the type of power supply that the server supports and
other information that you must consider when you install a hot-swap power supply:
Notes:
a. You must connect the signal cable to Port 0 on a ServeRAID-M1050 or
ServeRAID-M5014 adapter.
b. Secure the cable on the system board with cable tie after routing.
SAS/SATA signal
cable
Hard disk
drive backplane
8. Align the ServeRAID adapter so that the keys align correctly with the
connector on the PCI riser-card assembly.
9. Insert the ServeRAID adapter into the connector on the PCI riser-card
assembly until it is firmly seated.
Attention: Incomplete insertion might cause damage to the server or the
adapter.
riser-card assembly" on page 46).
Attention: When you install an adapter, make sure that the adapter is
correctly seated in the PCI riser-card assembly and that the PCI riser-card
assembly is securely seated in the riser-card connector on the system board
before you turn on the server. An incorrectly seated adapter might cause
damage to the system board, the PCI riser-card assembly, or the adapter.
configuration to the new ServeRAID adapter.
ServeRAID adapter
Chapter 2. Installing optional devices
43