Updating The Server Configuration - IBM System x3250 M4 Installation & User Manual

AC Power LED
(green)
AC Power LED
(green)
You must turn off the server before you connect or disconnect cables.
See the documentation that comes with any external devices for additional cabling
instructions. It might be easier for you to route cables before you connect the
devices to the server.
Cable identifiers are printed on the cables that come with the server and optional
devices. Use these identifiers to connect the cables to the correct connectors.

Updating the server configuration

When you start the server for the first time after you add or remove a device, you
might receive a message that the configuration has changed. The Setup utility
starts automatically so that you can save the new configuration settings.
Some optional devices have device drivers that you must install. For information
about installing device drivers, see the documentation that comes with each device.
If the server has an optional RAID adapter and you have installed or removed a
hard disk drive, see the documentation that comes with the RAID adapter for
information about reconfiguring the disk arrays.
For information about configuring the integrated Gigabit Ethernet controller, see
"Configuring the Gigabit Ethernet controller" on page 65.
Power-cord
connector
DC Power LED
Power-supply
(green)
error LED
(amber)
Power-cord
connector
AC
DC
DC Power LED
Power-supply
(green)
error LED
(amber)
Ethernet 1 Ethernet 1 Ethernet 2
link LED activity LED link LED
Serial
connector
NMI button
USB 3-4 connector
USB 1-2 connector
Video
connector
Ethernet 1 Ethernet 1 Ethernet 2
link LED activity LED link LED
Serial
connector
AC
DC
NMI button
USB 3-4 connector
USB 1-2 connector
Video
connector
Chapter 2. Installing optional devices
Ethernet 2
PCI slot 1
activity LED
Ethernet 2
PCI slot 1
activity LED
PCI slot 2
PCI slot 2
49