Using The Lsi Configuration Utility Program - IBM System x3250 M4 Installation & User Manual

2. Update the IMM2 firmware:
3. Configure the UEFI settings:

Using the LSI Configuration Utility program

Note: OPROM configuration utility is only available for emulex 10G card.
Use the LSI Configuration Utility program to configure and manage redundant array
of independent disks (RAID) arrays. Be sure to use this program as described in
this document.
v Use the LSI Configuration Utility program to perform the following tasks:
66
IBM System x3250 M4 Type 2583: Installation and User's Guide
a. Download the latest version of the UEFI code from http://www.ibm.com/
supportportal/.
b. Update the UEFI code, following the instructions that come with the update
file that you downloaded.
a. Download the latest version of the IMM2 firmware from
http://www.ibm.com/supportportal/ or http://www.ibm.com/support/fixcentral/.
b. Update the IMM2 firmware, following the instructions that come with the
update file that you downloaded.
a. When you are prompted to start the Configuration/Setup Utility program,
restart the server and press F1.
b. Select System Settings → Devices and I/O Ports.
c. Select Console Redirection Settings; then, make sure that the values are
set as follows:
v COM Port 1: Enable
v COM Port 2: Enable
v Remote Console: Disable
v Serial Port Sharing: Disable
v Serial Port Access Mode: Disable
v Legacy Option ROM Display: COM Port 1
v Baud Rate: 115200
v Data Bits: 8
v Parity: Select any of the following three options:
– None
– Odd
– Even
v Stop Bits: 1
Attention: In Linux operating system, if the number "2" is selected for
the Stop Bits setting, the Parity setting must be set to "None".
v Thermal Emulation: ANSI
v Active After Boot: Enable
v Flow Control: Hardware
d. Press Esc twice to exit the Devices and I/O Ports section of the
Configuration/Setup Utility program.
e. Select Save Settings; then, press Enter.
f. Press Enter to confirm.
g. Select Exit Setup; then, press Enter.
h. Make sure that Yes, exit the Setup Utility is selected; then, press Enter.