Configure Wpa/Wpa2-Psk - D-Link DIR-300 User Manual

Section  - Security
It is recommended to enable encryption on your wireless Router before your wireless network adapters. Please establish
wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption due to the added
overhead.
1. Log into the web-based configuration by opening a web browser and
entering the IP address of the router (192.168.0.1). Click on Wireless
Setup on the left side.
2. Next to Security Mode, select Enable WPA/WPA2 Wireless Security
(enhanced).
3. Next to Cipher Mode, select TKIP, AES, or Both.
4. Next to PSK/EAP, select PSK.
5. N e x t t o N e t w o r k K e y , e n t e r a k e y ( p a s s p h r a s e ) . T h e k e y i s a n a l p h a - n u m e r i c p a s s w o r d
between 8 and 63 characters long. The password can include symbols (!?*&_) and spaces. Make sure you enter this key exactly
the same on all other wireless clients.
6. Click Save Settings to save your settings. If you are configuring the Router with a wireless adapter, you will lose connectivity
until you enable WPA/WPA2-PSK on your adapter and enter the same passphrase as you did on the Router.
D-Link DIR-300 User Manual

Configure WPA/WPA2-PSK

8