Static (Assigned By Isp) - D-Link DIR-300 User Manual

Section 3 - Configuration
Select Static IP Address if all WAN IP information is provided to you by your ISP. You will need to enter in the IP address, subnet mask, gateway
address, and DNS address(es) provided to you by your ISP. Each IP address entered in the fields must be in the appropriate IP form, which are four
octets separated by a dot (x.x.x.x). The Router will not accept the IP address if it is not in this format.
IP Address:
Enter the IP address assigned by your ISP.
Subnet Mask:
Enter the Subnet Mask assigned by your ISP.
ISP Gateway:
Enter the Gateway assigned by your ISP.
MAC Address:
The default MAC Address is set to the WAN's physical
interface MAC address on the Broadband Router. It is
not recommended that you change the default MAC
address unless required by your ISP.
The default MAC address is set to the WAN's physical
Clone MAC
interface MAC address on the Broadband Router. You
Address:
can use the Clone MAC Address button to copy the
MAC address of the Ethernet Card installed by your
ISP and replace the WAN MAC address with the MAC
address of the router. It is not recommended that you
change the default MAC address unless required by
your ISP.
Enter the Primary DNS server IP address assigned by
Primary DNS
your ISP.
Address:
This is optional.
Secondary DNS
Address:
Maximum Transmission Unit - you may need to change
MTU:
the MTU for optimal performance with your specific
ISP. 1492 is the default MTU.
D-Link DIR-300 User Manual
Internet Setup

Static (assigned by ISP)