Configure Wep - D-Link DIR-300 User Manual

Section  - Security
It is recommended to enable encryption on your wireless router before your wireless network adapters. Please establish
wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption due to the added
overhead.
1. Log into the web-based configuration by opening a web browser and entering the IP address of the router (192.168.0.1). Click
on Wireless Setup on the left side.
2. Next to Security Mode, select Enable WEP Wireless Security (basic).
3. Next to Authentication, select either Shared Key or Open
Key is recommended as it provides greater security when WEP is
enabled.
4. Select either 64Bit or 128Bit encryption from the drop-down menu
next to WEP Encryption.
5. Next to Next to Default Key Type, select WEP Key 1 and enter a WEP key that
you create. Make sure you enter this key exactly on all your wireless
devices. You may enter up to four different keys either using Hex or
ASCII. Hex is recommended (letters A-F and numbers 0-9 are valid). In
ASCII all numbers and letters are valid. .
6. Click Save Settings to save your settings. If you are configuring the
router with a wireless adapter, you will lose connectivity until you enable WEP on your adapter and enter the same WEP key
as you did on the router.
D-Link DIR-300 User Manual

Configure WEP

Open. Shared