Configure Wpa/Wpa2 (Psk) - D-Link DIR-685 User Manual

Section 4 - Security
It is recommended to enable encryption on your wireless router before your wireless network adapters. Please establish
wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption due to
the added overhead.
1. Log into the web-based configuration by opening a web browser
and entering the IP address of the router (192.168.0.1). Click on
Setup and then click Wireless Setup on the left side.
2. Click the Manual Wireless Connection Setup button.
3. Next to Security Mode, select Enable WPA/WPA2 Wireless
Security (enhanced).
4. Next to Cypher Type, select TKIP, AES, or Both.
5. Next to PSK / EAP select PSK from the drop-down menu.
6. Next to Network Key, enter a key (passphrase). The key is
entered as a pass-phrase in ASCII format at both ends of the
wireless connection. The pass-phrase must be between 8 and
63 characters.
7. Click Save Settings to save your settings. If you are configuring the router with a wireless adapter, you will lose
connectivity until you enable WPA-PSK on your adapter and enter the same passphrase as you did on the router.
D-Link DIR-685 User Manual

Configure WPA/WPA2 (PSK)

111