Basic Operation - Denon AVR-1909 Owner's Manual

ENGLISH
Symbols used to indicate buttons in this manual
Button located on both the main unit and the remote control
unit
Button only on the main unit
Button only on the remote control unit
<SOURCE SELECT>
<ON/STANDBY> <STATUS>
[Front]
[OFF]
[iPod]
[2]
[1]
[6, 7]
[8, 9]
uiop
ENTER
[SOURCE
CONTROL 1]
[SOURCE
CONTROL 2]
0
iPod ® Playback
The music on an iPod can be played by using the control dock for
iPod (ASD-1R, ASD-11R, ASD-3N or ASD-3W sold separately).
BUTTON
The operation can also be performed using the buttons on the main
<BUTTON>
unit or remote control unit while watching the menus.
[BUTTON]
iPod is a trademark of Apple Inc., registered in the U.S.
and other countries.
ui
b The iPod may only be used to copy or play contents that are not
copyrighted or contents for which copying or playback is legally
permitted for your private use as an individual. Be sure to comply
with applicable copyright legislation.

Basic Operation

1
Make the necessary preparations.
ENTER, op
q S et the iPod in the DENON control dock for iPod.
(vSee the control dock for iPod's operating instructions.)
w Assign the control dock for iPod's input.
[Rear]
The input for the control dock for iPod is assigned to VCR by
default.
MENU : "Input Setup" – "Assign" – "iPod Dock"
(vpage 35)
2
<SOURCE SELECT>
Either turn
select the input source assigned in step 1-w above.
[TUNING+ –]
[MODE]
uiop
ENTER
b If the screens above are not displayed, the iPod may not be
properly connected. Try connecting again.
3
4
• With the default settings, the iPod can be used connected to the
• Use the RESTORER mode to expand the low and high frequency
[iPod]
or press to
• Press
• When using an ASD-3N or ASD-3W control dock for iPod, refer to
OK to disconnect.
(iPod screen)
[SOURCE CONTROL 1]
Set to "AUDIO" and
CONTROL 2]
to "iPod/NETWORK".
(vpage 56 "Remote Control Unit Operations")
[MODE]
Press and hold it down for a 2 seconds or
more to select the display mode.
To switch between modes, press and hold down the button.
When remote mode is active, "Remote" is displayed.
[Selectable mode] Browse mode
Display location Main unit display
Audio file
Playable S
files 1
Video file S z
Remote
control unit
Active S
(AVR-1909)
buttons
iPod
A
: When using an ASD-3N or ASD-3W control dock for iPod
z
1
z : Video may not be output, depending on the combination of
2
ASD-1R or ASD-11R and iPod.
VCR (iPod) connector.
components of compressed audio fi les and achieve a richer sound.
The default setting is "Mode3" (vpage 43).
<ON/STANDBY> [OFF]
or and set the AVR-1909's power to
the standby mode before disconnecting the iPod. Also switch the
input source to one to which the menu "iPod Dock" is not assigned
before disconnecting the iPod.
the respective manual to operate.
[SOURCE
Remote mode
iPod display
S
2
S z
S
S
.