Subwoofer Setup; Distance; Channel Level - Denon AVR-1909 Owner's Manual

s Subwoofer Setup
Select low range signal to be reproduced by subwoofer.
[Selectable items]
LFE
: Play low range and LFE signal of channels set to
"Small".
LFE+Main
: Play low range and LFE signal of all channels.
• This can be set when menu "Speaker Configuration" – "Subwoofer"
is set to "Yes".
• Play music or a movie source and select the mode offering the
strongest bass.
• Select "LFE+Main" if you want the bass signals to always be
produced from the subwoofer.
d Distance
Set distance from listening position to speakers.
Before making the settings, measure the distance from the
listening position to the different speakers.
Unit
Select unit for distance.
[Selectable items] Meters Feet
Step
Select step. (smallest distance)
[Selectable items]
0.1m 0.01m
: Can be selected when "Meters" is set.
1ft 0.1ft
: Can be selected when "Feet" is set.
Default
Reset the settings to the default values.
Distance measurement
Select the speaker you want to set, then set the distance.
Set the value closest to the measured distance.
[Variable range]
0.00m ~ 18.00m
: Display when "Meters" is set.
0.0ft ~ 60.0ft
: Display when "Feet" is set.
NOTE
Set the distance between the listening position and the various
speakers to no more than 6.00 meters (20.0 ft).
For details on how to select, set and cancel settings for each menu, see "Menu Operations" (vpage 17).
f Channel Level
Adjust channel levels to obtain equal volume from all speakers.
Test Tone
Select test tone playback method.
[Selectable items]
Auto
: Automatically switch speaker from which test tone is
output.
Manual
: Manually switch speaker from which test tone is output.
Test Tone Start
Output test tone.
z
–12dB ~
[Variable range] OFF 0dB
z In the case of a subwoofer, reducing the volume when it is at
"–12dB" will change the setting to "OFF" (none).
Default
Reset the settings to the default values.
Operating from the remote control unit
Adjusting with the remote control unit using the test tones is only
possible in the "Auto" mode and only effective in the STANDARD
mode. The adjusted levels for the different modes are automatically
stored in the memory.
GAdjusting using test tonesH
[TEST]
q Press .
Test tones are output from the various speakers.
w Use o p to adjust so that the volume is equal for all speakers.
e When the adjustments are completed, press
• When the menu "Speaker Configuration" – "Surround Back
Speaker" setting (vpage 24) is set to "1spkr", the surround back
speaker display is set to "SB".
• Speakers set to "None" in the "Speaker Configuration" settings are
not displayed.
• When "Channel Level" is adjusted, the adjusted values are set for all
the surround modes. To adjust the channel level separately for the
different surround modes, use the operation see page 54.
ENGLISH
~ +12dB
[TEST]
again.