Programming The Quantities Of Coffee And Milk In The Cup; Preparing Hot Water; Preparation; Changing The Quantity - DeLonghi ESAM 5500 Instructions Manual

When "Press CLEAN button" flashes on the display
(each time you use a milk function):
1. Leave the milk container in the machine (you
do not need to empty it);
2. Place a cup or other recipient under the milk
spout.
3. Press the CLEAN button (fig. 23) and keep pres-
sing until the progress bar which appears on
the display together with the message
"Cleaning..." is complete.
4. Remove the milk container and always clean
the nozzle with a sponge (fig. 24).
NB!
• When "Press CLEAN Button" flashes on the
display, you can still prepare any type of cof-
fee or milk. If you have to make a number of
drinks with milk, wait until you have delivered
the last cup before cleaning the container.
• The milk left in the milk container can be kept
in the refrigerator.
Programming the quantities of
coffee and milk in the cup
The appliance is factory preset to automatically
deliver standard quantities. To change these quan-
tities, proceed as follows:
1. Place a cup under the coffee spouts and milk
spout (fig. 21).
2. Press the CAPPUCCINO button (fig. 22) until
the message "Milk for Cappuccino Program
Quantity" is displayed.
3. Release the button. The appliance starts deli-
vering milk.
4. Once the required quantity of milk has been
delivered into the cup, press the CAPPUCCI-
NO button again.
5. After a few seconds, the appliance starts deli-
vering coffee into the cup and the message
"Coffee for Cappucc Program Quantity" is dis-
played.
6. Once the required quantity of milk has been
delivered into the cup, press the CAPPUCCINO
button again. Coffee delivery stops and
"READY" is displayed.
The machine is now reprogrammed with the new
quantities.

PREPARING HOT WATER

Preparation

Important! Danger of burns. Never leave
the coffee maker unsupervised while delivering
hot water. The hot water spout becomes hot while
water is being delivered and must be held by the
handle only.
1. Make sure the hot water spout (A19) is atta-
ched correctly (fig. 4).
2. Place a container under the spout (as close as
possible to avoid splashes).
3. Press the
"Hot Water..." is displayed.
4. Water is delivered from the spout. Delivery
stops automatically after 250 ml.
5. To interrupt delivery of hot water manually,
press the
Important: You should not deliver hot water
for more than two minutes at a time.

Changing the quantity

The appliance is factory preset to automatically
deliver 250 ml. To modify these quantities, pro-
ceed as follows:
1. Position a container under the spouts.
2. Press the
Water Program Quantity" is displayed.
• When the hot water in the cup reaches the
required level, press the
The machine is now reprogrammed with the new
quantity.
34
button (fig. 2). The message
button again.
button until the message "Hot
button again.