Cleaning The Milk Container After Each Use; Programming The Quantities Of Coffee And Milk In The Cup; Programming Cappuccino; Programming The Milk Menu Drinks - DeLonghi ECAM25462 Instructions For Use Manual

Bean to cup espresso and cappuccino machine
Hide thumbs Also See for ECAM25462:
Table of Contents

Advertisement

and (if needed for the drink), coffee delivery starts.
Pease note:
Milk or coffee dispensing can be interrupted at any time
by pressing the CAPPUCCINO or MILK MENU button accor-
ding to the drink selected.
At the end of delivery, to increase the quantity of milk or
coffee in the cup, within 3 seconds, press one of the but-
tons for milk-based drinks.
Do not leave the milk container out of the refrigerator for
long periods. The warmer the milk (5°C is ideal), the poo-
rer the quality of froth produced.

Cleaning the milk container after each use

Important! Danger of burns
When cleaning the internal tubes of the milk container, a little
hot water and steam leak out of the frothed milk spout. Avoid
contact with splashes of water.
"SET DIAL TO CLEAN" flashes on the display each time you use
a milk function. To eliminate all milk residues, proceed as fol-
lows:
1. Leave the milk container in the machine (you do not need
to empty it);
2. Place a cup or other recipient under the frothed milk
spout.
3. Turn the froth adjustment dial to "CLEAN" (fig. 22). A pro-
gress bar appears and gradually fills as the operation pro-
ceeds together with "Cleaning underway". Cleaning stops
automatically.
4. Turn the dial back to one of the froth selections.
5. Remove the milk container and always clean the steam
nozzle with a sponge (fig. 26).
Please note:
To prepare a number of cappuccinos or milk based drinks,
clean the milk container after you have prepared the last
drink only.
The milk container can be kept in the refrigerator.
In some cases, to clean you must wait for the appliance to
heat up.
Programming the quantities of coffee and milk in the
cup
The appliance is set by default to automatically deliver standard
quantities. To change these quantities, proceed as follows:
1. Place a cup under the coffee spouts and milk spout.

Programming cappuccino:

2. Hold the CAPPUCCINO button until the message "CAP-
PUCCINO PROGRAM MILK" IS DISPLAYED.
3. The appliance starts dispensing milk. Release the button.
4. Once the required quantity of milk has been delivered into
the cup, press the CAPPUCCINO button again.
5. After a few seconds, the appliance starts delivering coffee
into the cup and the message " CAPPUCCINO PROGRAM
COFFEE" is displayed.
6. Once the required quantity of coffee has been delivered
into the cup, press the CAPPUCCINO button.
Coffee delivery stops and the machine is "ready for use" again.
This completes programming.

Programming the MILK MENU drinks:

2. Press MILK MENU.
3. Turn the selection dial until the drink you want to pro-
gramme again is displayed (CAFFELATTE, MACCHIATO,
FLAT WHITE, MILK);
4. Hold down the MILK MENU button for a few seconds un-
til "(DRINK) PROGRAM MILK" IS DISPLAYED.
5. The appliance starts dispensing milk. Release the button.
6. Once the required quantity of milk has been delivered into
the cup, press the MILK MENU button again.
7. After a few seconds, if required by the drink, the appliance
starts delivering coffee into the cup and the message "
(DRINK) PROGRAM COFFEE" is displayed.
8. Once the required quantity of coffee has been delivered
into the cup, press the MILK MENU BUTTON.
Coffee delivery stops and the machine is "ready for use" again.
This completes programming.

MAKING HOT WATER

Danger of burns!
Never leave the machine unsupervised while hot water is being
delivered.
1. Make sure the hot water spout is attached correctly.
2. Place a container under the water spout (as close as possi-
ble to avoid splashes) (fig. 5).
3. Press the
button. "Hot water" is displayed, together
with a progress bar which fills gradually as preparation
proceeds.
4. Hot water delivery begins and then stops automatically.
To manually stop dispensing hot water, press
Please note :
If "Energy saving" mode is active, you may have to wait a few
seconds before the hot water is delivered.
Changing the quantity of water delivered automati-
cally
The machine is set by default to automatically dispense 250 ml
14
.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ecam25467

Table of Contents