Description Of Lights; Preliminary Checks; Controls After Transport; Installing The Appliance - DeLonghi ESAM 5500 Instructions Manual

C6. CAPPUCCINO
cappuccino or frothed milk.
C7. Selection dial: turn to select the
required quantity of coffee. (When in
the settings MENU, turn to select the
required function).
C8. Aroma selection button: to
select the coffee taste
C9. button: to perform a rinse cycle.
(When in the settings MENU, it acts as
the "ESC" button to exit from the
selected function and go back to the
main menu).
C10. P button: to access the settings menu.
C11. button: turns the appliance on and
off.

Description of lights

Indicates the need to descale the
appliance.
Indicates that the grounds container is
full and must be emptied.
Indicates that the water tank is empty
and must be filled with fresh water.
Indicates that the Auto-Start function is
active.
Indicates that an alarm is displayed.
Indicates the button to press to confirm
the choice in the menu.
Indicates the button to press to exit the
menu or selected function.
button: to deliver

PRELIMINARY CHECKS

Controls after transport

After removing the packaging, make sure the pro-
duct is complete and undamaged and that all
accessories are present. Do not use the appliance if
it is visibly damaged. Contact De'Longhi Customer
Services.

Installing the appliance

Important!
When you install the appliance, you should follow
the safety warnings below:
• The appliance gives off heat. After positioning
the appliance on the worktop, leave a space of
at least 3 cm between the surfaces of the
appliance and the side and rear walls and at
least 15 cm above the coffee maker.
• Water penetrating the coffee maker could
cause damage. Do not place the appliance
near taps or sinks.
• The appliance could be damaged if the water
it contains freezes. Do not install the coffee
maker in a room where the temperature could
drop below freezing point.
• Arrange the power cable in such a way that it
cannot be damaged by sharp edges or contact
with hot surfaces (e.g. electric hot plates).

Connecting the appliance

Important! Check that the mains power
supply voltage corresponds to the value indicated
on the rating plate on the bottom of the appliance.
Connect the appliance to an efficiently earthed and
correctly installed socket with a minimum current
rating of 10A only. If the power socket does not
match the plug on the appliance, have the socket
replaced with a suitable type by a qualified pro-
fessional.
28 28